Eco friendly, Biobased & emits low VOC’s
Easy to apply
Helps stabilize joint sand
Helps inhibit algae, weeds and ant hills
Single Component, so no mixing or waste
Natural biodegradability helps prevent sealer buildup and resists hazing
Use Cobble Coat H2O Wet on PAVERS ONLY
Cobble Coat H2O Wet is not recommended for pavers installed over a solid surface or on surfaces where moisture is unable to dissipate.
Application Roller: Apply with a 3/8” to 3/4” nap roller cover.
Avoid over rolling.
Always maintain a wet edge. Do not pool or over apply.
Airless Sprayer: Spray by overlapping each pass.
Always apply in an even film deposit and maintain a working wet line.
Cobble Coat H20 Wet
Cobble Coat H20 Wet is the newest technology in waterborne protection for concrete brick pavers.
Cobble Coat H20 Wet is a wet look waterborne sealer designed to provide the dark wet look without the harsh smell or harmful effects of solvent, while still providing excellent UV light protection.
Cobble Coat H20 Wet provides stain resistance and is specially designed for DIY use.
One coat gives a dark wet look on most surfaces, two coats provide a sheen.
Before You Begin: Surfaces must be clean and free of any contaminants before sealing.
Cobble Coat H2O Wet’s performance is directly related to how thoroughly the surfaced is prepared. All grease, oil, and potential contaminates must be removed.
Do not apply when the temperature of the air or the surface to be coated is below 50°F. Testing on your surface is always recommended to ensure desired results.
Surface Preparation: Brick pavers should be installed a minimum of 28 days before sealing.
Read label instructions carefully. Cobble Clean, Cobble Prep & Cobble Oxhide may be used for specific cleaning situations.
Mixing Instructions: Stir product, some separation may occur and will easily mix in.