Cobble Coat H2O Wet

Cobble Coat H20 Wet

Wet-Look Appearance, Semi Gloss Finish
SKU#:  235

Cobble Coat H20 Wet is the newest technology in waterborne protection for concrete brick pavers.

Cobble Coat H20 Wet Wet is a wet look waterborne sealer designed to provide the dark wet look without the harsh smell or harmful effects of solvent, while still providing excellent UV light protection.

Cobble Coat H20 Wetprovides stain resistance and is specially designed for DIY use. One coat gives a dark wet look on most surfaces, two coats provide a sheen.

See how Cobble Coat H20 Wet sealer compares to other sealers:

Eco friendly, Biobased & emits low VOC’s • Easy to apply • Helps stabilize joint sand • Helps inhibit algae, weeds and ant hills • Single Component, so no mixing or waste • Natural biodegradability helps prevent sealer buildup and resists hazing
Use Cobble Coat H2O Wet on driveways, patios, pool decks, parking lots, walkways, etc. constructed of: Concrete Pavers Only Cobble Coat H2O Wet is not recommended for pavers installed over a solid surface or on surfaces where moist moisture is unable to dissipate.
Before You Begin: Surfaces must be clean and free of any contaminants before sealing. Cobble Coat H2O Wet’s performance is directly related to how thoroughly the surfaced is prepared. All grease, oil, and potential contaminates must be removed. Do not apply when the temperature of the air or the surface to be coated is below 50°F. Testing on your surface is always recommended to ensure desired results. Surface Preparation: Brick pavers should be installed a minimum of 28 days before sealing. Read label instructions carefully. Cobble Clean, Cobble Prep & Cobble Oxhide may be used for specific cleaning situations. Mixing Instructions: Stir product, some separation may occur and will easily mix in. Application Roller: Apply with a 3/8” to 3/4” nap roller cover. Avoid over rolling. Always maintain a wet edge. Do not pool or over apply. Airless Sprayer: Spray by overlapping each pass. Always apply in an even film deposit and maintain a working wet line. On Bare Surface: One and sometimes two thin coats (2 dry mils) provide the best results on uncoated surfaces. Previously Sealed: One coat is recommended. Do not apply Cobble Coat H2O Wet more frequently than every 12 months to avoid a build up of sealer
MSDS available at request
ECO Earth Friendly Formulation
Product Video



 
 
 
Subscribe  Newsletter
 
Follow Us
 
 
Contact  SurfaceLogix