SurfaceLogix' Texture Deck System has been the standard for concrete resurfacing since 1985. Use the Texture Deck Bags with the RTU resin or 48% resin concentrate to create a variety of patterns on old and new concrete. When mixed properly, the Texture Deck System can be applied to create a knock-down texture finish, stone finish, and a variety of patterns using tape or stencils.
-
Economical concrete resurfacer
-
Stronger than conventional concrete
-
Unlimited patterns and designs on concrete
-
Works on old and new concrete
-
Product for decorative concrete resurfacing
-
Pool decks
-
Driveways
-
Patios
-
Walkways
-
Concrete Decor
Apply the Texture Deck System to clean and dry concrete. Smooth concrete will need to be acid etched. A coat of cut resin can be applied as a bonding agent to ensure better adhesion. Wait 30 minutes after rolled bond coat is applied and no longer than 5 days to do the job.
In a clean 5 gallon pail start with 4 to 5 quarts of RTU resin or the 48% concentrate resin (cut in half with water 50/50). Slowly add, with drill mixer ready in bucket, one 50lb Texture Deck bag of powder. Mix entire bag into the bucket until a uniform pancake batter consistency is achieved. Allow to sit for 3 minutes then add a pint clean water on top of the blend and remix for 1 minute. Use this bucket up within 45 minutes as the product will begin to set up.
READ LABEL THOROUGHLY BEFORE APPLYING PRODUCT